Those of you who are familiar with our blog might remember a post about this pizza-oven. The same customers called us again saying that it stopped working again. But this time it seemed to be working bet was not baking anything - so it was not heating up. Our tech started checking power supply circuits. One of the coils was getting power supply of 120VAC, but the other one was not. The tech familiarized himself with the circuit design. He found out that the latter coil was getting power supply from the switch from the motor. The motor was not starting when the oven was on, and therefore the switch was not closing either. The motor had to be replaced.
We offer appliance repair at competitive prices in San Francisco Bay Area, including the following counties:
Contra Costa Country
Santa Clara County
San Mateo County
San Francisco County
Double oven had an issue with lower bake element. It wouldn’t heat up to a certain temperature and newer goes above 200 degrees. When our technician checked the voltage coming to an element it showed 120 instead of necessary 220-240, which leaded to a control board relay board problem. We had to order a new power board and replace it in order to made it back to normal.
A couple of weeks before the customer detected the problem with her top-loading GE washer, there were repairs done on the cold water pipe-system. Dirt and mud from the pipes clogged up the hose filter, preventing normal water flow. That’s why the washer was filling so slowly. Our tech cleaned the hoses and the washer started filling water perfectly.
The Samsung RF287AERS fridge was acting out, making noises and not keeping the food cold enough. During the diagnostic, our tech noticed that the defrost sensor was showing around 20MOhms when frozen. It was clear that the defrost sensor was defective and had to be replaced.