Front loading washers have a door seal which is also known as a washer gasket or a door boot. When the gasket is worn out or damaged, your washer might be leaking water. Our customer needed the washer gasket to be replaced and called us.
When replacing the gasket you need to get to the place where it sits. In most cases you need to deattach the door. The gasket is always comes with a spring that prevent it from falling off. Locate the spring and take it out. Don't forget to put the spring back, make sure the spring is tight enough and won't let the gasket move freely.
In our case the washer seal (gasket) was damaged and caused the leakage. Don't use the sharp tools like screwdrier while installing the new seal. Sharp objects may damage the gasket.
Once replaced, the new gasket will hold the water and prevent your washer from leaking.
We offer appliance repair at competitive prices in San Francisco Bay Area, including the following counties:
Contra Costa Country
Santa Clara County
San Mateo County
San Francisco County
Double oven had an issue with lower bake element. It wouldn’t heat up to a certain temperature and newer goes above 200 degrees. When our technician checked the voltage coming to an element it showed 120 instead of necessary 220-240, which leaded to a control board relay board problem. We had to order a new power board and replace it in order to made it back to normal.
A couple of weeks before the customer detected the problem with her top-loading GE washer, there were repairs done on the cold water pipe-system. Dirt and mud from the pipes clogged up the hose filter, preventing normal water flow. That’s why the washer was filling so slowly. Our tech cleaned the hoses and the washer started filling water perfectly.
The Samsung RF287AERS fridge was acting out, making noises and not keeping the food cold enough. During the diagnostic, our tech noticed that the defrost sensor was showing around 20MOhms when frozen. It was clear that the defrost sensor was defective and had to be replaced.